Drew

Excavated and installed a 2” gray water line around the home, tying it into the main sewer line. Replaced the sewer line beginning approximately 8 feet beyond the concrete pad. Excavated across the driveway and installed a 4” sleeve for added protection, then transitioned from 3” to 4” piping beyond the sleeve. Excavated and prepared the tank area, set the tank, and ensured it was properly leveled using a transit. Installed the tight line and began chamber installation, completing two 60-foot rows based on site grade. Chambers were installed starting at 30” depth and ending at approximately 20”, then properly felted. Driveway was backfilled to allow homeowner access as needed; area is covered but will require final cleanup.

Installed and properly wrapped all chamber rows, maintaining a consistent depth of approximately 26–30 inches across 95% of the system. Performed initial grading to achieve proper elevation before installation, ensuring optimal depth without over-excavation. Completed two chamber rows distributed in four directions. Relocated and worked around an existing wood pile as needed, including additional grading to maintain consistent depth requirements.

Dug hole and leveled it. Set tank and leveled it. Installed sewer line with clean out and baffle. Installed power from disconnect to control box. Installed 120’ of sprinkler line with 2 heads 30’ 360° spray with drains and pads.

Swapped float wires, greased control bar. Disconnect is on, breakers in control box off. System needs water. Went over warranty info.

Cleaned up and backfilled.

Installed 70’ of water line from main shut off under water heater, up into attic and down the wall. Installed new whole house filter and installed new NOVO system.